Follow animatedknots on Twitter
Advert
Animated Knots by Grog

TIE KNOTS THE FUN AND EASY WAY

Better to know a knot and not need it, than need a knot and not know it.

Brummel Eye Splice for Hollow Braid Rope

indeximageindeximageIndexLeft
Splicing Index Splicing Usage

Back Splice Eye Splice Chain Splice Splice, Short Brummel Demo Locked Brummel Splice Brummel McDonald Long Bury Splice Grog Sling Grog's Sliding Splice Soft Shackle Soft Shackle Edwards

Knot Terminology Knot & Rope Safety Rope Properties Contact About
Use the Arrow Keys or hover over the Buttons above. View Video

Making a Brummel Eye Splice

Mark the length needed for the eye. Make a hole at each mark and pass the end through and pull. Choose the hole nearest the end and pull a bight and the other hole through. Then, through the second hole pull a bight. Snug the splice together and pull the short end through the center of the standing end.

Brummel Eye Splice Details

Warning: in practice use a much longer tail and a more gradual taper – see below. The short ends were used here to allow close-up photography. The technique tends to be confusing and repetition is required to memorize and master the details.

Make the Lock with One End: The animation shows how the Locked Brummel is tied when only the working end is available to be threaded through the rope. It is, of course, much easier to tie when both ends are available, because then there is no need to invert the two holes first.

Measure: Mark the length of the long buried end by measuring off 72 diameters of the rope, e.g., 3 feet for a half-inch rope. Then measure off the length required for the final eye plus 3 rope diameters and make a second mark. Note: this additional length is necessary because the splice consumes some of this measured length.

Create Two Inverted Holes: The whole key to making a Brummel splice is the creation of Brummel holes with spiral twisted sides. When a bight is passed back through them later, it restores the twists back to normal without using the long end. The two holes can be made in any order. Each hole should be made by carefully separating the strands – exactly an equal number on each side of the hole. The process of passing the end through the rope, creates the Brummel hole. The two holes should be made so that they line up and face the same direction. The section between these holes becomes the "Eye".

Restore the First Hole: Choose the hole nearest the end and tuck the Eye through the hole followed by the second hole and some extra rope. This process can be awkward. It helps to stretch the hole first. A large fid may help or a bight of line can be wrapped around the rope and used to pull it through.

Restore the Second Hole: Tuck the Eye through the second hole. Now, the fibers around both holes are restored to normal and the Brummel lock is complete.

Dress the Splice: This process may have restored the spiral twists around the sides of each hole but the rope is still distorted. The rope either side of the holes should be massaged back to restore normal spacing of the strands. Snug the two holes together. These maneuvers achieve exactly the same result as when both ends are available.

Finishing the Splice: For maximum strength and reliability, the long tail end is tapered, buried, and stitched. Finally the throat of the splice is whipped - see detailed descriptions of these procedures in the Long Bury Splice.

Simpler Method: To obtain the same result using a simpler technique, visit the McDonald Brummel page.

Disclaimer: Any activity that involves ropes is potentially hazardous. Lives may be at risk - possibly your own. Considerable attention and effort have been made to ensure that these descriptions are accurate. However, many critical factors cannot be controlled, including: the choice of materials; the age, size, and condition of ropes; and the accuracy with which these descriptions have been followed. No responsibility is accepted for incidents arising from the use of this material.

Copyright © 2007 - 2014
All Rights Reserved Grog LLC
    Copyright and Trademark    
Version 4.0.1. Nov 24, 2014

iPad App – New

ipad More Options
Full Screen
Features ++

Android App

Android PhoneUpdated Version
Move to SD Card
Added Sections

iPhone App

iPhone Updated Version
Added Sections
More Features

Get the Program

Download a Copy
for your own computer.

Disk