Knot List: Long Bury Splice ‐ Step-by-Step
Home Page References Press Reviews Testimonials F.A.Q. Thanks Grog Story
Terminology Safety Rope Properties Which Rope Essential Knots About Contact Knot Store
Speed LoopMirror Flip
Use Arrow Keys
Long Bury SplicingFor tapering mark 6 strands, choosing alternate pairs. Pull these six strands out of the rope and cut them off close to the rope. Pass the splicing tool up the hollow core of the rope. Tuck the tapered tail into the tool and pull it through the rope. Smooth out the rope to bury the end.
Long Bury Splicing Details
Warning: in practice use a much longer tail and a more gradual taper – see below. The short lengths were used here just for photography.
Nomenclature: Some authors refer to this as a Brummel - a Brummel without a lock. We prefer to reserve the name Brummel for the Locked Splice and use Long Bury Splice to describe this splice. In fact both the Brummel and the Long Bury have a critical feature in common: they both derive their strength from the long buried tail.
Long Bury technique: The animation shows how to tie a Splice using the Long Bury technique – with no "Lock". When tested to destruction, the Long Bury splice should not be a weak point – the standing end of the rope may break first. The strength of the splice relies on the long tail being gripped by the standing end; the strain is progressively transferred from the standing end to the two lines of the eye.
Material: This splicing technique is particularly suitable for un-sheathed, high modulus, loosely woven, 8, 12, 16, 20, or 24-strand, single braid ropes. These ropes include: High-Modulus Polyethylene (HMPE), e.g., Spectra, Dyneema or Amsteel; Liquid Crystal Aromatic Polyester (LCAP), e.g., Vectran; or Aramid fibers, e.g., Kevlar, Nomex, Technora, or Twaron. The loose weave results in the angle of the fibers being nearly parallel to the axis with minimal kinking. The ropes have impressive strengths but they also have impressive drawbacks: knots or kinks can reduce the breaking strain of some materials to a mere 30%. The splicing technique described here imposes almost no kinking or compression on the rope's fibers and breaking strains in the 90 - 100% range are to be expected.
Requirements: At first glance this seems to be a simple way of making an eye splice – just thread the end up the middle. However, several requirements must be met to achieve both reliability and strength:
Shortening: The long buried tail expands the rope and shortens it. There is no reliable formula for predicting the result because the settings used in the manufacturing process vary the tightness/looseness of the hollow braid construction. The following technique works when preparing rigging for a mast. Before making the first splice, make a mark well away from the end, e.g., 15 feet. Then measure the lengths to be used for the eye and the tail and make the splice. Measure how much the splice has shortened the end of the rope. Apply enough load to "reset" the braid the way it will lay in use. Measure again. Use this information to calculate the length of rope required and try to make an identical splice on the other end.
Disclaimer: Any activity that involves ropes is potentially hazardous. Lives may be at risk - possibly your own. Considerable attention and effort have been made to ensure that these descriptions are accurate. However, many critical factors cannot be controlled, including: the choice of materials; the age, size, and condition of ropes; and the accuracy with which these descriptions have been followed. No responsibility is accepted for incidents arising from the use of this material.