TIE KNOTS THE FUN AND EASY WAY
Better to know a knot and not need it, than need a knot and not know it.
Scouting Index Scouting Requirements
Alpine Butterfly Loop Back Splice Barrel Hitch Bowline Cleat Hitch (Halyard) Clove Hitch (End) Coil Unattached Rope Constrictor (Twisting) Double Fisherman's Double O'hand Stopper Eye Splice Figure 8 Half Hitch Lashing, Square Lashing, Diagonal Lashing, Round Lashing, Shear Lashing, Tripod Marlinspike Hitch Midshipman's Hitch Rolling Hitch Round Turn & Hitches Sailmaker's Whipping Sheet Bend Sheepshank Square (Reef) Timber Hitch Trucker's Hitch Whipping (Common)
Knot Terminology Knot & Rope Safety Rope Properties Contact About Facebook
Use the Arrow Keys or hover over the Buttons above. View Video
Sheepshank Knot TyingFold the rope to approximately the desired new length. Form a Half Hitch in one standing end, drop it over the adjacent bight, and tighten it. Form a Half Hitch in the other standing end, drop it over its adjacent bight, and then tighten it too. Apply the load carefully.
Sheepshank Knot Details
Avoid Using It: With the possible exceptions below, the Sheepshank should never be used. It is only included here because Boy Scouts used to be required to learn it. Ashley described Sheepshanks (ABOK # 1152 - 1154, p 210) but cautioned that they "......should be seized or otherwise secured to make them safe unless the need is very temporary...."
Failure Under Load: Some modern synthetic materials tend to be flexible and slippery. The illustration here shows a correctly tied sheepshank failing under modest load. This is a piece of three strand nylon rope and this failure was reproduced easily and repeatedly.
Eliminate It: If you are asked to learn to tie the Sheepshank, please request your Troop Leader to eliminate this knot and replace it with something safe and useful, e.g., the Alpine Butterfly Loop is an excellent way of creating a loop in the middle of a length of rope and can also be safely used to shorten a rope.
Bellringer's Knot: Bellringer's use just one end of a Sheepshank to keep the tail of the rope off the ground when not being used.
Practical Limitations: In practice, the Sheepshank would be almost impossible to tie under load; shortening one end and re-securing the line would be preferable. As a knot, it cannot pass through blocks or sheaves.
In the critical environments presented by climbing, search and rescue, and boating, there are no applications where the Sheepshank would offer an acceptable solution.
Possible Exceptions: A modern neckband can be a closed loop with no access to the ends. If your neckband is too long, the Sheepshank may be used to shorten it. We were recently part of a travel group issued with receivers to hear our guide. We all found the neckbands inconveniently long and preferred using them shortened as shown here.
Another suggested use for the Sheepshank is the protection of a damaged or weakened piece of rope. A more secure alternative is the Alpine Butterfly Loop.
Disclaimer: Any activity that involves ropes is potentially hazardous. Lives may be at risk - possibly your own. Considerable attention and effort have been made to ensure that these descriptions are accurate. However, many critical factors cannot be controlled, including: the choice of materials; the age, size, and condition of ropes; and the accuracy with which these descriptions have been followed. No responsibility is accepted for incidents arising from the use of this material.